Page 24 - Haddonstone
P. 24

24

    5.1 	Transporting the Units

    During transit the following points should         for which they were designed, either
    be considered:                                     by grab or forklift, using suitable forks.
                                                       Under no circumstances should scaffold
    • A suitable vehicle e.g. rigid or articulated    poles, timbers etc. be used to carry or
      trailer preferably with air suspension           support the pallets.
      should be used for transport.
                                                     • When using grabs, these should grip the
    • Units should be covered during transit          pallet, not the product.
      to protect them from saturation and
      staining.                                      • Slings should not be used unless
                                                       previously discussed with the
    • Bearers should provide adequate                 manufacturer.
      support to prevent incidents of point
      loading of the units.                          • Where slings are used to lift individual
                                                       units, the arrises of the unit should be
    • Pallets should be designed to withstand         protected and the sling positioned to
      the load which they are to carry                 provide an even support.

    • Palletised deliveries of cast stone
      should be unloaded by the mechanism

    5.2 	Site Storage

    Once the product is on site the following        • Products should remain packaged until
    guidelines should be followed:                     immediately prior to use.

    • Palletised products should be stored on       • When unpacking the product, strapping/
      flat, level, dry ground at a safe distance       packaging should be carefully cut, not
      from other trades, roadways, etc. to             ‘burst open’. Ensure that care is taken
      prevent damage to the aesthetics and             when cutting the packaging so that the
      structure of the product. Runners should         face of the stone is not damaged by the
      be used to support pallets on soft ground.       knife blade.

    • Never stack pallets of products on top of     • It is important that opened packs of
      one another.                                     cast stone are covered with polythene
                                                       sheeting to prevent the ingress of water,
    • Individual units should not be stacked          dirt or dust.
      face to face without appropriate interface
      material (manufacturers packaging and          The UKCSA has produced a cartoon-
      protective materials should be used for        based site poster for the safe handling
      this).                                         of cast stone. It can be downloaded from
                                                     www.ukcsa.co.uk
    • Individual units should be suitably
      supported by timber or plastic bearers.
   19   20   21   22   23   24   25   26   27   28   29